![]() ![]() Make sure to push the pipe all the way into each fitting using the marking you made in Step 6. Don’t worry if the pipe stays coiled, it will straighten out as fittings are attached.Ĭonnect the Blu-Lock pipe to the Hose to Blu-Lock adapter, tees, elbows, and couplings where you made your cuts. This mark will help you know how far to push the fittings on to the Blu-Lock pipe. Mark the Blu-Lock pipe one inch from the end before installing the fittings. It is okay to have extra parts left over when you are done we added parts for varying layouts.Ĭonnect the timer to the desired faucet and then connect the Hose to ½” Blu-Lock adapter to the timer.Ĭut the pipe where tees, elbows, and couplings will be located. ![]() If you have the 2-zone kit, adapt this design for your second zone.To ensure proper pressure and spray coverage of your lawn, do not put any more than three sprinkler heads on any length of pipe.Orbit recommends the U-shaped design shown in this manual, but this design can be adapted to the unique shape of your landscape.Ideally the sprinkler heads’ spray pattern will spray over each head a short distance. While you are waiting for the pipe, you can move on to the next few steps.įor optimal coverage and health of your plants, locate each sprinkler so that the spray distance reaches adjacent sprinklers. Let the pipe rest in the sun for approximately one hour (depending on how warm it is outside), which will make the pipe easier to put into place.Unroll the 125′ coil of pipe, making sure not to kink the pipe in the process.Distance will vary if the nozzle is changed. Performance will vary based on your design, and whether or not you choose to use all of the sprinkler heads in the kit. Use this chart to help you determine how far apart to space your heads.ĭistances are approximate and based on the Orbit recommended, U-shaped, design. Your available pressure will determine how far your sprinkler heads will spray water. STEP 2 Determining Sprinkler Head Spacing Orbit is not responsible for damage or harm caused by not installing and maintaining the appropriate backflow prevention device. The home’s backflow device must be compliant with local and federal plumbing codes. If your faucet does not have a backflow device, such as a vacuum breaker, make sure to install one before attaching this sprinkler system. In order to keep your drinking water safe and free of hazards, all faucets must be protected against the possibility of water flowing backwards from this irrigation system, into the home. Call days in advance to give the utility companies time to mark their lines on your property. Call before you dig in most areas dial 8-1-1. Call utility providers to mark utility lines. It is important that you check with your city, county, state, and municipal water agencies to learn the local codes and permit requirements for sprinkler systems. 5 Related Posts Complete Sprinkler System Kitįor instructions in Spanish, visit: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |